door stop.pdf
(
372 KB
)
Pobierz
Slide 1
Door Stop
Door Stop
Lessons:
•
Applies to Wolf Elective 3d – Make it Yourself
• Practice sawing
• Something useful
• Easy: appropriate for Wolf or Bear
Tools:
• Saw (Japanese style pullsaw recommended)
• Clamp
• Ruler
Materials:
• A block of wood, approximately 1½ inch thick, at
least 4 x 6 inches. Dimensions are not critical.
• A piece of 2 x 4 will do, but…
• For extra style points, the block of wood can be
made of several pieces of contrasting wood,
glued together!
• Sandpaper: 150 grit aluminum oxide paper to finish,
perhaps some coarser grits to start (100 or 80)
• Optionally, you can use an oil finish, such as boiled
linseed oil. Oil finishes won’t get scratched by the
door!
Door Stop
dimensions are not critical!
Procedure:
• The door stop is made by cutting the corner off of the
board.
1. Mark a cut line on the board
2. Clamp the board to the work surface
2
Door Stop
Procedure:
3. Cut the door stop with a saw, starting at the large
end of the door stop
• The boy should stand with his arm in line with
the cut line.
• Have somebody stand on the opposite side of
the board from him to give advise if the saw is
tilted left or right.
• After the first inch or so of cut, the saw’s
direction is set. Attempting to “steer” the saw
will only produce a cut surface that is not flat.
3
3
Door Stop
Procedure:
4. Sand the cut surface by rubbing it on a piece of
sandpaper on a hard surface (a table).
5. Wipe a minimal amount of linseed oil on the door
stop, if you like.
•
See the safety note on the next page!
5
5
6
Plik z chomika:
gumisx32
Inne pliki z tego folderu:
Building a wooden box.avi
(181989 KB)
Dual-Purpose Bench.pdf
(939 KB)
Drill Recharge Station.pdf
(77 KB)
drill bit speed chart.pdf
(18 KB)
Drewniany ścisk stolarski.pdf
(643 KB)
Inne foldery tego chomika:
Książki
Książki o stolarstwie
Narzędzia i techniki
Projekty
STOLARSTWO
Zgłoś jeśli
naruszono regulamin