Peerless_HDS134_850488.pdf

850488

HDS 134 - 5" MID-WOOFER SHIELDED CAST

WOOFER/MID 5" - 134 WR 26 90 SD AL

A truly high end mid-woofer with a rigid aerodynamic cast aluminium basket and ventilated spider. All aspects of this

drivers design and manufacture achieves superior engineering with the lowest possible compression, maximum exertion

of the cone, excellent ventilation, etc. Attractive modern style. Inverted dust cap. Suitable for higher power, high SPL,

maintaining excellent dynamics and efficiency at any volume. The one piece cast aluminium basket provides the

necessary sturdy base for the magnet structure and suspension and allows for a long excursion of the cone. The spider is

ventilated to the basket, this achieves the lowest possible compression and to allow air to flow freely to create a cooling

effect for the voice coil and therefor greatly extend the long term power tolerance. The design of the basket fascia

allows for very slim box designs and the edges are cambered to reduce the necessary amount of counter sinking. Hex

screw holes. The three or five layer sandwich cone improves accuracy and consistency of sound reproduction over the

entire frequency range, creating a more "musical" driver. Due to the soft suspension, an excellent dynamic small signal

reproduction is obtained. Other features are high sensitivity, gold plated terminals and very low harmonic and difference

tone distortion. This woofer is applicable on a wide range of applications, and is especially ideal for very compact 2-

way bookshelf boxes (as small as 5L ported), for satellite systems as mains (Closed box 3L - 6L suggested) or as

surround sound units. Also popular as multiple alignment floorstanding boxes, MTM centres, etc., Multiple driver

boxes make this highly sensitive unit even more efficient. Peerless recommend that this highly dampened speaker is

best suited to ported designs tuned to 65Hz in a 10L box. Upper crossover recommended 1500 to 4500Hz.

Parameters

Free-Air Common Baffled

Nominal impedance

(ohm)

Minimum impedance/at freq. Zmin (ohm/Hz)

6.4/376

Maximum impedance

(ohm)

34.6

DC resistance

(ohm)

5.7

Voice coil inductance

(mH)

1.0

Capacitor in series with 8 ohm

(for impedance compensation) Cc

(µF)

Resonance Frequency

(Hz)

61.1

59.9

Mechanical Q factor

Qms

2.07

2.11

Electrical Q factor

Qes

0.41

.42

Total Q factor

Qts

0.34

0.35

F (Ratio fs/Qts)

(Hz)

172

Mechanical resistance

Rms

(Kg/s)

1.89

Moving mass

Mms

(g)

10.2

10.6

Suspension compliance

Cms

(mm/N)

0.67

Effective cone diameter

(cm)

10.8

Effective piston area

(cm²)

Equivalent volume

VAS

(ltrs)

7.6

Force factor

(N/A)

7.4

Reference voltage sensitivity

Re 2.83V 1m at 376 Hz (Measured)

(dB)

89.2

Voice coil diameter

(mm)

Voice coil length

(mm)

Voice coil layers

Flux density in gap

(T)

1.24

Total useful flux

(mWb)

0.83

Height of the gap

(mm)

Diameter of magnet

(mm)

Height of magnet

(mm)

Weight of magnet

(kg)

0.4

Code

850488

850488

HDS 134 - 5" MID-WOOFER SHIELDED CAST

Peerless Recommend: "F ratio (fs/Qts) for this driver is and this indicates that the damping is high.

The best way to use this driver is in a vented box with the following suggested box sizes.

10 ltr box. 1 port. Diameter 40 mm. Lenght 55 mm. Tuning freq 65 Hz. Response, - 3 dB appr at 62 Hz.

10 ltr box. 1 port. Diameter 55 mm. Lenght 120 mm. Tuning freq 65 Hz. Response, - 3 dB appr at 62 Hz.

5 ltr box. 1 port. Diameter 30 mm. Lenght 45 mm. Tuning freq 78 Hz. Response, - 3 dB appr at 85 Hz.

For small satellites it would be best to use the driver in a closed box. Box sizes from 3-6 ltr will be suitable.

Cross-over freq between 1500-4500 Hz is recommendable for this model."

172

152mm

60mm

Speaker Infinite Baffle Response Curve

5mmØ

Rear Ventilated

Dustcap & Spider

Projected Box Frequency Response Curves

Page 2/2

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: