sliderstickers.pdf

(2528 KB) Pobierz
Slider Stickers
Slider Stickers
By Marian Chivers
MATERIALS REQUIRED:
Creative Images: CIM217A
Victorian Girls & Snowman.
Creative Borders: CB019P
Pale Blue Christmas.
Creative Paper:
SR067P Wintry Sky.
Pearl Card: CNT107C Red
and CNT103C White.
Mirri Card: MIR02C Silver.
Gold Label Peel Offs:
ZL649U-82 Rope Borders.
Red/Gold Ribbon.
2 Small Christmas Trees.
Clear Glitter Glue: GLI56.
Sticky Fixers: ADH05.
Double Sided Tape: ADH13.
Hole Punch and Embossing Tool.
Craft Knife, Cutting Mat and Ruler.
1c. Emboss another fold line exactly half way across
each panel as shown (blue dashed line). Push both
panels through to the front a little.
1mm Deep Mini Fixers: ADH27.
Card Mount: DEC6C-103 White Pearl.
TO MAKE THE CARD:
2
1a. Lay the card open and face down. On the left
hand panel, mark two rectangles measuring 57mm x
74mm, positioned 10mm from each edge as shown.
If you have marked it all correctly there will be a
10mm gap between them in the centre too.
1b. Use a ruler and embossing tool to score the left
hand end of each oblong (red line). Use a knife and
ruler to cut the other three sides of both panels.
2. Turn the card over keeping the cut-outs to the left.
Fold both of the scored lines on each panel to make
little hills and leave them folded for now.
10mm
Score
Push Through
3a
1b
Score
Score
10mm
10m
10m
10mm
1a
Score
Push Through
3b
1c
Score
10mm
10m
10m
10mm
30
10m
10m
10mm
743365780.136.png 743365780.147.png 743365780.158.png 743365780.169.png 743365780.001.png 743365780.012.png 743365780.023.png 743365780.034.png 743365780.045.png 743365780.056.png 743365780.067.png 743365780.078.png 743365780.089.png 743365780.095.png 743365780.096.png 743365780.097.png 743365780.098.png 743365780.099.png 743365780.100.png 743365780.101.png 743365780.102.png 743365780.103.png 743365780.104.png 743365780.105.png 743365780.106.png 743365780.107.png 743365780.108.png 743365780.109.png 743365780.110.png 743365780.111.png 743365780.112.png 743365780.113.png 743365780.114.png 743365780.115.png 743365780.116.png 743365780.117.png 743365780.118.png 743365780.119.png 743365780.120.png 743365780.121.png 743365780.122.png 743365780.123.png 743365780.124.png 743365780.125.png 743365780.126.png 743365780.127.png 743365780.128.png 743365780.129.png 743365780.130.png 743365780.131.png 743365780.132.png 743365780.133.png 743365780.134.png 743365780.135.png 743365780.137.png 743365780.138.png 743365780.139.png 743365780.140.png 743365780.141.png 743365780.142.png 743365780.143.png 743365780.144.png 743365780.145.png 743365780.146.png 743365780.148.png 743365780.149.png 743365780.150.png 743365780.151.png 743365780.152.png 743365780.153.png 743365780.154.png 743365780.155.png 743365780.156.png 743365780.157.png 743365780.159.png 743365780.160.png 743365780.161.png 743365780.162.png 743365780.163.png 743365780.164.png 743365780.165.png 743365780.166.png 743365780.167.png 743365780.168.png 743365780.170.png 743365780.171.png 743365780.172.png 743365780.173.png 743365780.174.png 743365780.175.png
3a. Cut two pieces of white card to 10cm x 5cm.
Score and fold one end of each up at 1cm from the
edge. Unfold and add a strip of double sided tape to
the folded end. Place the folded end through one
aperture under the ‘hill’ folded flap.
3b. Make sure the strips are central in the apertures,
peel off the tape backing and stick to the flaps.
from the tape.
Press the two
ends of ribbon
neatly together
and trim.
Place a strip
of holly border
across each
slider just below
the punched
hole. Add a strip
of rope border on both sides and trim all neatly to the
edge of the slider. Press all pieces as flat as possible
so they don’t catch as the strip slides in and out.
Stick a strip of rope border around both apertures.
Cut two panels of red card to 65mm x 85mm and
two silver panels to 55mm x 75mm. Stick the silver
to the red and place a large sticker in the centre of
each. Stick one to each of the bottom halves of the
folded flaps.
Cut the Happy Christmas border so you have one
set of words with a dot at each end and stick this to
a piece of silver card. Cut around it to leave a 2mm
silver border. Stick this to a piece of red card and
trim around it to leave a 2mm red border. Make an-
other in the same way.
Fold the flaps so the picture panels stand up and
sticky fix the word panels onto the sky paper 10mm
from the lower edge of the apertures, the bottom of
the picture panels will tuck neatly behind these to
keep the panels in the upright position.
Place a holly border 15mm in from the fold and
add a rope border each side, trimming all of these to
the edge of the card.
Stick one of the small Victorian stickers to silver
card and trim around it to leave a 2mm silver bor-
der. Mount onto red card and trim to leave a 2mm
red border. Sticky fix this panel over the centre of
the holly border as shown.
Add a small tree over the border on both sides
of this panel, if you don’t have anything similar
you could used glitter stickers on acetate
and mount using sticky fixers for depth.
Add some sparkle by using a little
clear glitter on the snow and the
fur trims on the coats of the girls.
Sky Paper
on Back
4
4. Cut a piece of sky paper to 90mm x 140mm and
stick to the inside back panel placing it centrally from
top to bottom and 12mm from the right hand edge.
This allows it to show behind the apertures once the
card is folded, except for a 2mm strip at the right
edge, to keep it clear of the sliders. This 2mm gap is
not visible when the card is assembled.
Inside of
Card
5
5. Work on the back of the front panel making sure
no tape is placed in the way of the sliders at the left
edge. Place tape along the three edges of the panel
as shown. Use a 1mm deep mini fixer at the edge of
the card between the apertures as shown and add a
strip of tape along next to it. Place another strip to
the right of the apertures and add a couple of strips
to fill in the open area to the right as shown.
Make sure the flaps are unfolded as shown in dia-
gram 5, before folding the back panel over onto
the tape pressing it firmly to seal.
6. With the card face up, fold the ‘hill’
flaps back up, which will push the slider
ends out. Punch a hole in the centre of
each slider close to the end.
Use the photo on the right to
guide you as you complete the card.
Cut a 7cm length of ribbon and place
double sided tape along half of it. Push one end
of the ribbon through the hole, remove the backing
31
6
743365780.176.png 743365780.177.png 743365780.178.png 743365780.179.png 743365780.002.png 743365780.003.png 743365780.004.png 743365780.005.png 743365780.006.png 743365780.007.png 743365780.008.png 743365780.009.png 743365780.010.png 743365780.011.png 743365780.013.png 743365780.014.png 743365780.015.png 743365780.016.png 743365780.017.png 743365780.018.png 743365780.019.png 743365780.020.png 743365780.021.png 743365780.022.png 743365780.024.png 743365780.025.png 743365780.026.png 743365780.027.png 743365780.028.png 743365780.029.png 743365780.030.png 743365780.031.png 743365780.032.png 743365780.033.png 743365780.035.png 743365780.036.png 743365780.037.png 743365780.038.png 743365780.039.png 743365780.040.png 743365780.041.png 743365780.042.png 743365780.043.png 743365780.044.png 743365780.046.png 743365780.047.png 743365780.048.png 743365780.049.png 743365780.050.png 743365780.051.png 743365780.052.png 743365780.053.png 743365780.054.png 743365780.055.png 743365780.057.png 743365780.058.png 743365780.059.png 743365780.060.png 743365780.061.png 743365780.062.png 743365780.063.png 743365780.064.png 743365780.065.png 743365780.066.png 743365780.068.png 743365780.069.png 743365780.070.png 743365780.071.png 743365780.072.png 743365780.073.png 743365780.074.png 743365780.075.png 743365780.076.png 743365780.077.png 743365780.079.png 743365780.080.png 743365780.081.png 743365780.082.png 743365780.083.png 743365780.084.png 743365780.085.png 743365780.086.png 743365780.087.png 743365780.088.png 743365780.090.png 743365780.091.png 743365780.092.png
Issue 58
Autumn 2010
Hello,
We hope you enjoy this free article taken from a back issue of the Craft Creations
Magazine. You may hand make copies of the card(s) featured in this project, to
give away or sell, as many times as you like. You may not use the project, text,
pattern or pictures for any other purpose nor make the project using any kind of
automated process.
All the free articles available for download on our web site are at least one year
old. If you want the latest projects, designer profiles, gallery pages and more,
then you need to subscribe to the quarterly Craft Creations Magazine.
Subscription Benefits:
* A free gift with every issue.
* 10% off every order placed with Craft Creations*.
* £2.50 off post and packing on orders over £20*.
* Prize competitions in every issue.
You can subscribe to the quarterly Craft Creations Magazine or purchase any of
the back issues from our online shop - www.craftcreations.com
* All Craft Creations Magazine subscribers will receive an additional 10% discount off their orders during
their subscription period only. Subscribers will also receive £2.50 off post and packing on orders over £20
(after discount). These benefits are not applicable on certain items such as: Magazine Subscriptions, Gift
Vouchers, Products already on Promotion, Special Offers or 'SPOF' packs and cannot be combined with
any other vouchers or offers. * At the present time all UK orders over £20 get free Post and Packing.
Craft Creations Limited
Ingersoll House, Delamare Road, Cheshunt, Hertfordshire, EN8 9HD, England.
Tel: 01992 781900 Fax: 01992 634339 Web: www.craftcreations.com
The details above are correct as of 16th September 2011, but are subject to change without prior notice.
The UK’s Original Greetings Card Making Magazine - Full Of Creative Ideas
743365780.093.png 743365780.094.png
Zgłoś jeśli naruszono regulamin