Psychoscareapy2.0.pdf

Please note that this project is not recommended for children. It requires a moderate degree of skill, and the use of a cutting blade, which is extremely

dangerous. When using cutting blades always use protective eyewear. Color printing is recommended. This model was designed to be printed on

Matte Paper Heavyweight, and the use of white glue is recommended.

There are many folds in the model, and it is recommended that you score the fold first, using a dull cutting blade, or other fine, blunt tipped instrument.

Black dashed lines represent a mountain fold (a fold which point upward), and orange dashed lines represent a valley fold (the fold points downward).

The orange dashed lines are accompanied by a red “+” at each end. These are to be used as pin guides, so you can poke small holes at the “+”, flip the

sheet over, and score between the holes for a clean valley fold. Read the instructions and study the illustrations carefully before beginning.

Before removing pieces from

sheet, cut all indicated slots.

Optional:

Remove windows from

sections 2B, 5A and 7A

as shown, leaving the bars.

Optional:

Score, cut and fold

6 first floor window

inserts 4A and 7 second floor

window inserts 9E.

Glue piece 2A into entry

section 1A, inserting the tab

on 1A into slot on 2A. Align

and glue side tabs to be flush

with edges of 1A entry door.

Fold and attach inner room

piece 4B as shown and glue

behind entry section 2A, making sure

edges are flush.

Page 1 of 12

Fold down and glue roof section

of 3A , with tabs inside and top

flush with top edges.

Also fold down and glue the 2

smaller roof sections.

Glue floor section 3B into

the bottom of the entry

section, with long tab

aligned with the rear edge.

Glue edge tabs of rear piece

3A to 1A.

Align and glue the edge tab

of rear piece 8A to 5A.

Glue window insert behind each

window opening.

Align and glue the edge tab

of rear piece 6A to 7A.

Glue window insert behind each

window opening. Windows 9E on

second floor and 4A on first floor.

Align and glue the edge tabs

of rear pieces to front pieces.

Fold down and glue roof sections

flush with top edges.

Insert and glue floor sections 8B and 6B

up into the bottoms of the left and right

structure wings*.

Gently bend the lettering 9A

so the tabs fit into the slots on 9A.

Glue into place

Fold porch section 9A as shown.

Carefully glue the front strip to the

triangles, being sure that

all of the edges are flush.

* Only the left wing shown.

Page 2 of 12

Glue window 9E behind window opening

on piece 2B (optional).

Fold and glue window 2B as shown.

Glue window 2B into slot on

the ledge above the front entryway.

Insert tabs on bottom of flagpole pieces

9C and 9D into slots on top edges.

Glue tabs on porch roof

into the slots above the front entry.

Glue the left and right

structural wings to the central

structure. Align the REAR edges.

The central structure should

extend from the front.

Page 3 of 12

< 3 SLOTS

Page 4 of 12

< SLOT

SLOT >

Page 5 of 12

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: