PSP 1000 Repair Manual.pdf

(2952 KB) Pobierz
Installing PSP 1000 Speakers
Installing PSP 1000 Speakers
Tools used in this guide
Spudger (1)
This guide will show you how to remove and replace your PSP speakers.
© 2010 iFixit — CC BY-NC-SA
www.iFixit.com
Page 1 of 10
1010293207.051.png 1010293207.062.png 1010293207.069.png 1010293207.070.png 1010293207.001.png 1010293207.002.png 1010293207.003.png 1010293207.004.png 1010293207.005.png
Installing PSP 1000 Speakers
Step 1 - Battery
Turn the PSP over so its back is facing you.
Step 2
Locate the battery casing button on the rear-left side of
the PSP.
Press down the button and remove the battery cover.
© 2010 iFixit — CC BY-NC-SA
www.iFixit.com
Page 2 of 10
1010293207.006.png 1010293207.007.png 1010293207.008.png 1010293207.009.png 1010293207.010.png 1010293207.011.png 1010293207.012.png 1010293207.013.png 1010293207.014.png 1010293207.015.png 1010293207.016.png 1010293207.017.png 1010293207.018.png
Installing PSP 1000 Speakers
Step 3
Using your finger, remove the battery upwards from the
system as shown.
Step 4 - Front Casing
Remove the screws, with a phillips #00 screwdriver,
shown.
Be sure to sort the screws by their sizes and
where they were located originally on the
device so you can find them easily and put
them back correctly during reassembly.
© 2010 iFixit — CC BY-NC-SA
www.iFixit.com
Page 3 of 10
1010293207.019.png 1010293207.020.png 1010293207.021.png 1010293207.022.png 1010293207.023.png 1010293207.024.png 1010293207.025.png 1010293207.026.png 1010293207.027.png 1010293207.028.png 1010293207.029.png 1010293207.030.png 1010293207.031.png 1010293207.032.png 1010293207.033.png 1010293207.034.png 1010293207.035.png
Installing PSP 1000 Speakers
Step 5
Remove the screw from the bottom side of the PSP.
Keep it separated from the rest of the screws.
Step 6
Gently separate the outer plastic casing from the rest of
the system as shown.
© 2010 iFixit — CC BY-NC-SA
www.iFixit.com
Page 4 of 10
1010293207.036.png 1010293207.037.png 1010293207.038.png 1010293207.039.png 1010293207.040.png 1010293207.041.png 1010293207.042.png 1010293207.043.png 1010293207.044.png 1010293207.045.png 1010293207.046.png 1010293207.047.png
Installing PSP 1000 Speakers
Step 7 - LCD Screen
The Button Board, at the base of the LCD Screen, is
held by two clips.
Pry these clips over the nubs using a PSP opening tool.
This will release the clips.
The Button Board is still attatched to the
PSP by a ribbon cable!
Step 8
The Button Board Ribbon Cable is held down with a
latch. Lift the latch open, away from the ribbon cable.
Pull the cable away from the latch.
© 2010 iFixit — CC BY-NC-SA
www.iFixit.com
Page 5 of 10
1010293207.048.png 1010293207.049.png 1010293207.050.png 1010293207.052.png 1010293207.053.png 1010293207.054.png 1010293207.055.png 1010293207.056.png 1010293207.057.png 1010293207.058.png 1010293207.059.png 1010293207.060.png 1010293207.061.png 1010293207.063.png 1010293207.064.png 1010293207.065.png 1010293207.066.png 1010293207.067.png 1010293207.068.png
Zgłoś jeśli naruszono regulamin