Esseltine-Xmas-Tree-Ornament.pdf
(
21 KB
)
Pobierz
208838876 UNPDF
Christmas tree Ornament (2000)
By: Charles Esseltine
1.) Start white side up. Fold
in half. Unfold
2.) Fold the sides into the
centerline.
3.) Fold the model in half so
That the end points meet.
Unfold
4.) Fold the top point to
meet the new crease.
Unfold
5.) Fold bottom over the
edge of the colored section.
6.) Fold down to form trunk.
Like this.
7.) Wrap the inner layers
around the trunk. Then flip
over.
If you are using a LARGE
piece of paper, you can add
more pleats.
8.) Zoom in. Fold the bottom
tip upwards. Tuck the tip under
the front edge.
9.) Pleat
10.) Let's take a close look at one of the
lower pleats. Swivel fold the corner, so
that a small bit of the tip falls below the
bottom edge..
11 a.) Swivel fold to narrow
the point. Leave the tip
below the edge alone.
11 b.) Swivel fold complete.
12.) Now repeat steps 10 and
11 on the other side.
13.) Squash one of the
upper pleat tips. This is
similar to step 10, but this
one goes to the tip.
13a.) Swivel fold the ends,
to make the point sharper..
14b.) Swivel fold complete.
15.) Now repeat steps 13 and
14 on the other side.
16.) Pleats complete! Now flip
the model over, and look at it
from the bottom.
17.) Fold the model, at a right
angle, down the centerline
18.) Soft crease the ends so
that the model forms a tripod
base, that the model will stand
on.
To turn it into an ornament add a bit
of twisted wire to the point at step 7.
Plik z chomika:
kingadabrowska31
Inne pliki z tego folderu:
stefalotus1.gif
(9 KB)
star2.gif
(33 KB)
star1.gif
(34 KB)
SnowflakeCP.pdf
(330 KB)
sam5.gif
(16 KB)
Inne foldery tego chomika:
Aniołki
Balonowa bombka
Bombka
Boże Narodzenie
Boże Narodzenie(1)
Zgłoś jeśli
naruszono regulamin