1. Two MF-1 are printed.
MF-5MF-6, MF-7, and MF-8 are stuck on MF-1.
MF-5,MF-6, MF-7, and MF-8 are stuck on MF-1 of two sheets.
A hole is made in four places.
(I recommend you to use thicker paper for this part. Or please stick two sheets of
papers and make it strong.)
2. MF-2 MF-3 of a side part and MF-4 are attached from a reverse-side side.
Four reinforcement parts R-2 are attached like a photograph
3. A, B, C, and D are attached from a reverse-side side.
A and B are the parts for tops. And C and D are the parts for the bottoms.
4. R-1 which is reinforcement parts, and R-3 are attached in both sides as shown in a figure.
5. Four holes are made in MF-22 and E, G, and F are attached from a reverse-side side. Parts X and Y are attached in MF-21.
6. MF-22 are stuck on a main part.
7. MF-9, MF-13, MF-20, and MF-21 are attached.
8. The back attaches MF-25 similarly. MF-10, MF-16, MF-23, MF-24, MF-35, MF-44, MF-45, and MF-17 are attached. MF-11 are attached in MF-10.
9. MF-18, MF-19, and MF-27 are attached.
10. An antenna is made from MF-28, and 29, 30, 31, 32 and 33.
11. 2 sets of laser canon is made from MF-36, MF-37, and MF-26.(The upper photograph)A under photograph is a simple version. Parts are MF-36, MF-37, and MF-38.
12. A cockpit is made and attached by MF-39, MF-40, MF-41, MF-42, and MF-43. MF-14 and the parts made from MF-15 are attached in both sides.
13. A heat dissipation mouth is made and attached by MF-46 and MF-47. MF-48 are attached in both sides.
14. MF-12 and the parts made from MF-49 are attached in vertical both sides. Canon is attached on it. An antenna is inserted.
15. Z-4 and Z-5 are attached.
16. A display is made and it is completion!
17. Addition of Detail parts. Z-1,Z-2 and Z-3 are attached.
18. Z-6 are attached.
19. Completion.
tomsmola1