CARPROG Motorola HC11 programmer manual.pdf

(11135 KB) Pobierz
Microsoft Word - CARPROG Motorola HC11 programmer manual.doc
S4.4 CarProg Motorola HC11 Programmer manual
For Motorola MPU MC68HC11 series programming use A10 cable.
You can recognize Motorola (Freescale) MPU by maskset:
This MPU maskset is 4C11W.
First digit Ð4Ñ is mask series number, in practice can be 0, 1, 2, 3, 4 or 5, but for
programming is not important.
All right reserved www.codecard.lt
1
730670950.011.png 730670950.012.png 730670950.013.png
Second 4 symbols is always letter + digit + digit + letter: this is processor maskset or
encrypted processor type. All processor marking can by custom made, like ÐFORD
S2234234Ñ or SC2323454 but always you can find maskset on Motorola or Freescale
processors.
Before programming always select right processor type according maskset.
All right reserved www.codecard.lt
2
730670950.014.png 730670950.001.png 730670950.002.png
How to connect CarProg programmer:
For HC11 programming use A10 cable 7 color wires:
YELOW Î communication signal from MPU;
GREEN Î communication signal to MPU;
BLUE Î Reset signal to MPU;
ORANGE Î MODB signal to MPU, low level;
BROWN Î GND (ground);
RED Î switched +5V;
VIOLET - switched +12V;
All right reserved www.codecard.lt
3
730670950.003.png 730670950.004.png
Troubleshooting:
CarProg ERROR messages:
Communication error - no communication between CarProg and Motorola processor -
check MPU type, try to select quartz frequency manualy.
MC68HC11 processor security bit in many case is ON (especially in car radios), and
when you try to read MPU internal memory first time, MPU will clear security bit itself. But if
security bit was ON, after first try to read HC11, processor internal EEPROM will by lost.
Don't try to read HC11 MPU if you not sure that you have file for EEPROM recovery.
To understand better onboard MPU programming problems, you can use table with right
programming signals and voltages, described in table.
If you canÓt read or write MPU with CarProg, check:
- did you was select right MPU type;
- did quartz resonator Q is the same in circuit board and in CarProg options;
- did all programming signals have right form and voltage;
Yellow
TXD
From MPU
Green
RXD
To MPU
Orange
LOW
MODB
Blue
RESET
All HC11 MPU
Impulse
3.3-5V
Impulse
3.3-5V
0 V
If all conditions are OK, ask support@codecard.lt
All right reserved www.codecard.lt
4
730670950.005.png 730670950.006.png 730670950.007.png 730670950.008.png 730670950.009.png
1. MC68HC11A0, MC68HC11A1, MC68HC11A8
All right reserved www.codecard.lt
5
730670950.010.png
Zgłoś jeśli naruszono regulamin